Stainless Steel Vertical Liquid Level Float Switch, 10cm

Installation Manual

• Vertically mounted float switch install in the top or bottom of the tank (inside of the tank).
• Magnets within the float actuate a highly reliable and repeatable hermetically sealed reed switch as the float rises and lowers with liquid level.
• Single-pole single-throw (SPST) circuitry.
• Configure for normally open or normally closed circuit connection.
• When installed on top of the tank and used for sensing when liquid rises to a certain level (default setting), the sensor will be "normally closed" and will open when the liquid reaches that level.
• When installed on the bottom of the tank and used for sensing the drop in the liquid level beyond a certain point, the sensor will be "normally open" and will close when the liquid drops to that level.
• To change the default setting to "normally open", simply remove the bottom clip; remove, flip and replace the float; and reinstall the clip.
• IP68-rated water and dust protection.
• Max pressure: 217.5 psi (1.5 MPa)
• Float specific gravity: 0.7
• Material: SUS304 /SUS316L stainless steel
• Gasket material: NBR
• Cable length: 15 in (381 mm)
• Wire gauge: 26 AWG
• Wire type: Teflon
• Includes two gel-filled butt splice connectors for extending the cable length up to 1,000 feet.
• Connect to digital input or RJ45 sensor port on an E-2D/5D/16D.
• To connect to the RJ45 inputs, use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor cables using the included butt splice connectors.
• Float Diameter: 1.1 in (28 mm)
• Stem length: E-LLS-SF-10CM: 3.93 in (100 mm). E-LLS-SF-25CM: 9.84 in (250 mm)
• Operating temperature: -4 to 194 F (-20 to 90 C).
• Electrical rating: AC 220V/1A; DC 24V/0.5A
• Mounting thread: M10x1.5